Atlas Copco Dynapac F1000W T4i, Руководство по эксплуатации и техническому обслуживанию

Страница: 161 / 240

E 01 5
E_1.
0_01_
US.fm. 5-10
2.5 Mounting support tube extensions
If the working width exceeds 23 ft. (7.01 m.), an
auger crossbeam extension must be mounted.
The support tube extension of the auger cross-
beam consists of two halves (8) and is attached
to the existing support tube by using a total of 5
screws. After the two halves have been screwed
to the support tube, they also must be linked to
each other by means of screwed connections.
Clamping of the telescopic tube occurs
by tightening the screwed connections
(9) linking the support tube extension.
If the working width exceeds 14 ft. (6.26 m.) the hydraulic hoses (10) for the auger
motors must be replaced with longer ones.
These long hoses are included in the scope of delivery for this working width.
When connecting or disconnecting hydraulic hoses, hydraulic fluid can spray out at a
high pressure and can cut or enter the skin.
Switch the paver off and de-pressurize the hydraulic circuit! Protect your eyes!
When installing the hoses, make sure that the area around the connections is clean.
Any contaminants that enter the hydraulic system can cause damage to the hydraulic
system.
8
9