Atlas Copco 8432084561, Инструкция по эксплуатации продукта

Страница: 10 / 16

Operation EN ETD MT41-100-I06
10
© Atlas Copco Industrial Technique AB - 9839 1064 01
Configuration Instructions
Tighten joint
To start the tightening process, press the start lever (A). By default, you need to hold the lever during the
whole tightening process.
For other start modes, refer to Start options [Page 11] .
The front light will turn red if the tightening is fault.
Unscrew joint
There are two unscrew modes:
■
Standard (default): run the tool in CCW.
■
Single reverse : run the tool in CCW once and shift back in CW when tightening is ready.
To start the unscrew process:
1. Press the function button (B) once. The reverse light (C) is on.
If the reverse light (C) is flashing, single reverse mode is selected.
2. press the start lever (A).