the basic requirements of IEC 61340-5-1 and EN
100015-1.
The condition for use in an EPA (Electrostatic
Protected Area) is that the installation of the screw-
driver will ensure that the body of the tool discharge
to ground and that the drive is placed outside of the
EPA area.
During operation the tool will be connected to
ground through the mains cord.
Safety
Statement of use
This product is designed for installing and removing
threaded fasteners in wood, metal or plastic.
No other use permitted. For professional use only.
If the tool is equipped with a reaction bar
The reaction bar is designed for absorbing the reac-
tion torque of assembly power tools.
No other use is permitted. For professional use
only.
Warning / Important
T
All locally legislated safety rules regarding
installation, operation and maintenance shall
be respected at all times.
Storage and transport
• The components should be stored at a dry place,
and should be protected from dust and aggressive
media. High variation of temperature should be
avoided.
• Each connection should be removed before trans-
port to avoid breaking the connecting cables.
Use sufficient insulation of the shipping packet
to protect components against damage.
Installation safety
• Refer installation to qualified personnel only.
• Always make sure that the mains plug is discon-
nected and the controller is turned off before
connecting or disconnecting the tool cable.
Operation safety
• This product shall only be operated indoors in a
dry environment.
• This product must not be used in explosive atmo-
spheres.
• This tool is intended for an operational frequency
with a maximum of 3000 tightenings during an 8
hour work day, including at least a 2-3 seconds
rest time between the tightenings. For more fre-
quent or long period of use, it is recommended to
alternate between two tools.
The tool is not recommended to be used for long
screws with high rundown torque, in those applic-
ations we recommend the use of Atlas Copco
pneumatic screwdrivers.
Maintenance safety
• Cleaning of the components and the connecting
cables should not be done with solvent containing
cleanser.
• Trouble-shooting and re-start of the system may
only be carried out by an authorized person.
• Refer servicing to qualified personnel only.
Safety instructions
General power tool safety warnings
T
WARNING
Read all safety warnings and all instructions.
Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-oper-
ated (cordless) power tool.
T
Work area safety
• Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
• Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable li-
quids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
• Keep children and bystanders away while operat-
ing a power tool. Distractions can cause you to
lose control.
T
Electrical safety
• Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any ad-
apter plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will re-
duce risk of electric shock.
• Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and refri-
gerators. There is an increased risk of electric
shock if your body is earthed or grounded.
• Do not expose power tools to rain or wet condi-
tions. Water entering a power tool will increase
the risk of electric shock.
• Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
© Atlas Copco Industrial Technique AB - 9836 2880 00
4
EBL35
EN
Safety Information