Atlantis Solar SK Series, Инструкция по установке и эксплуатации

Страница: 29 / 51

29
Notice: The maximal electric current of the Atlantis Solar Air conditioner refers to the
maximal input electric current, which is printed on the brand of the indoor unit. The
maximal electric current of the circuit refers to the total summation of the maximal electric
current, which comprises the maximal electric current of the Atlantis Solar Air-conditioner
and the maximal electric current of other appliance.
The electric security requirement of installation of Atlantis Solar Air conditioner
1. Power cord of indoor and outdoor units cannot adopt polyvinyl chloride, and must adopt
chloroprene rubber wires (including high-tension signal wires). It is forbidden to lengthen
or shorten the wires by yourself. The exceedingly long wire of electric source should be
folded as large round curves. It is strictly forbidden to wind wires into small circles.
2. The ground wire must adopt yellow and green wires with adequate wire size. The
ground wire is strictly prohibited to connect to pipe of tap water, pipe of coal gas, zero line
of electric source, and overhead ground wire.
3. When you connect wires, please refer to the electric circuit diagram in the machine and
ensure everything is correct.
Please install the air conditioner at a place, which is provided with following
characteristics.
1
）
） ）
）
Indoor Unit
①
Indoor unit should be installed upon a firm vibrationless wall.
②
Entrance and vent are supposed to be expedite. The hot wind and the cool wind are
supposed to should blow toward all around the room.
③
Indoor unit should be installed where it is convenient to connect with the outdoor unit.
④
Indoor unit Installation should avoid direct solar radiation.
⑤
Indoor unit should be installed where drainage is convenient.
⑥
Indoor unit Installation should consider about future maintenance. The filter screen
should be dismountable.
⑦
Indoor unit Installation should ensure the spaces which are shown in the following
picture.