3) Standby (Hors Gel) Mode
It is the mode enabling to maintain a temperature of approximately 7°C in the room in case of prolonged
absence from the house.
a) Leave switch
on the Marche position.
b) Set the knob
to .
4) Turbo mode
It is the mode enabling to set the device into Forced Operation, ensuring prompt temperature increa-
se in the room over the time defined (maximum power for conventional models and fan activation point
for models with ventilating fan).
a) Leave the switch
on the Marche position.
b) Select the time for the Turbo using the knob .
c) Press the command , the indicator
lights.
d) The TURBO mode can be interrupted manually before the end of the time set. In order to do this,
press the command
again.
NB: On a piloted or independently programmed appliance, only the Stop and Anti-frost instructions have
priority when the TURBO mode is activated (the other instructions are ineffective).
5) Locking commands
It is possible to lock the knob
or restrict its use, preventing untimely handling of the device –(chil-
dren…).
1- Locking the knob:
a) Set the knob to the position required.
b) Using a small-size flat-blade screwdriver, pull the knob’s cap (1).
c) Detach pin
P from its stand using a cutting tool.
d) Set pin
P in the alignment of arrow B (2).
e) Refit the cap.
2- Limitation of the knob’s use range:
a) Using a small-size flat-blade screwdriver, pull the knob’s cap (1).
b) Remove the two
P pins from their stand using a cutting tool.
c) Position the two
P pins at each end of the operating range desired (3).
d) Refit the cap.
- When ventilating the room, stop the device by setting the switch
to the Arrêt position.
- If you leave for several hours, lower the temperature.
Leaving for:
Less than 24 hours
:do not touch the controls.
More than 24 hours or during summer :set the temperature knob to .
R
ECOMMENDATIONS OF USE
B
2
3
P
P
1
