F6 - VIEW DEFAULT PARAMETERS - Lists the default parameters of the presently installed
printhead, including the maximum voltage level recommended by the manufacturer for a
nominal resistance printhead.
F7 - INVOKE PLOT UTILITY - Executes the TECH-GRAPH-PAD program to allow the
generation of dynamic sensitivity curves without terminating the MODEL 200 operating
system software.
F8 - CONFIGURE TEST SYSTEM - Enables/disables the SAMPLE mode option. When in
SAMPLE mode, the test sessions are not saved in a file therefore the operator is not prompted for
a file name.
F10 - EXIT FROM TESTER - Allows the operator to leave the test system environment and
return to DOS
NOTE:
TEST file names MUST conform to the following rules:
- At least one character long, but less than eight characters in length.
File names may ONLY be made up from the following characters:
- The letters A - Z, and a - z
- The numbers 0 - 9
- The following special characters:
( ) { } @ # $ % ^ & ! - _ ' ~
Any attempt to create a file that is outside this guideline will prompt the "ILLEGAL FILE
NAME" error message to appear.
