ATL IP300S, Руководство пользователя, Страница: 56 / 100

IP SIP Phone v2 User’s Guide Mar. 2005
[56/100]
c. Set the interval.
A l a r t I n t e r v A l :
[ 1 0 - 6 0 0 ] s e c 6
0
d. Alternatively, you may go to web page
『
IP SIP Phone
』
/
『
Preferences
』
=>
“Hold Recall Alerting Timeout (s)” to configure it.
10.4. Auto Hold on Call Switch
Enable the “Hold on call switch” feature will automatically put calls on hold whenever the
user performs call switch by pressing
【
A / B /
】
C Call . If this feature is disabled, the phone treats
call-switch as disconnection signal: hanging up the active call then switch to designated call.
Note: Press the button standing for current call has no effect, such as pressing
【 】
A Call
during A-line is active has no effect.
To configure Dial timeout:
a.
Press
【 】
FUNC +
【 】
# to activate menu.
b. Go to submenu “5. Preferences” / “4. Hold on Switch”.
c. Set your preference.
1 . E n a b l e d .
2 . D i s a b l e d
d. Alternatively, you may go to web page
『
IP SIP Phone
』
/
『
Preferences
』
=> “Auto Hold
on Call Switch” to configure it.
System default is enabled.
10.5. Auto Redial
You can configure when to stop auto-redial (once activated) by going to
【
MENU
】=>
“5.Preferences” / “ 5.Auto-Redial” / “1. Stop Criterion” to specify the stop criterion:
1 . R i n g i n g
2 . C o n n e c t E d
1. Only when the peer starts ringing back will auto-redialing stops (Default).
2. Only when the peer picks up will auto-redialing stops.
When you dial a number and fail to reach the peer, you will hear a busy tone. You can press
【
Auto-redial
】
to activate this feature. When the auto-redial is in progress, the corresponding
LED will be on, and it will re-dial the failed number ‘till the stop criterion is met or this feature is
canceled. To cancel auto-redial manually, press
【
Auto-redial
】
again. This feature will be
automatically canceled if either the stop criterion is met or the total activation duration is
expired.
The total activation duration is configurable by
【
MENU
】 =>
“5.Preferences” /
“ 5.Auto-Redial” / “3. Total Duration”. Default is 1800 seconds (30 minutes).