ATL IP300S, Руководство пользователя, Страница: 46 / 100

IP SIP Phone v2 User’s Guide Mar. 2005
[46/100]
Hold Recall” by keypad or web configuration page
『
IP SIP Phone
』
/
『
Preferences
』
=> “Hold Recall Alerting Timeout (s) “):
z
If you are in on-hook state:
i. The phone will ring.
ii.
【 】
The green LED of A Call flash fast.
iii. The recall state continues ‘till user picks up the call. However, if user does not
answer the call within 1 minute, the call will be disconnected.
z If you are in off-hook state, either engaged in other calls or about to making calls:
i.
【 】
The green LED of A Call flashes slowly but the ringer does not ring.
ii. Play hold recall tone once to remind the user that some calls are in hold.
iii. Reset the hold recall timer for next time alarm.
3. If the user is put on hold by the peer, LCD will show:
B e H e l d m m : s s
M i c H a e L
Note: if you are held by the peer, IP SIP Phone will play music-on-hold.
9.3. Mute
m m : s s
M i c H a e l
z Set up a connected call.
z Press
【
MUTE
】
to toggle your voice transmission. On muting state, the red LED of
【
MUTE
】
will be on, and you can hear still the peer’s voice; however they cannot hear
you.
9.4. Transfer
Call Transfer allows a user, on any existing two-party call, to place the existing call on hold
and originate another call to a third party. The user may consult privately or connect the original
call to the third party.
There are two types of transfers:
z Blind Transfer—With blind transfer you transfer the caller to another party without
announcing the caller to the called party. To blind transfer a caller, you would press
【
XFER
】
to place the caller on hold. You will hear a dial tone and can dial the
number you want to transfer the call to. It will immediately transfer the call and you
could hang up as soon as finishing dialing or wait until the 3
rd
party picks up then