ATL Delta 700, Руководство пользователя

Страница: 10 / 24

Installing the Batteries
Batteries must be installed to power the
display while the phone is on-hook as
well as to save telephone settings.
1. In order to install the batteries,
make sure the desk/wall mount is not
attached to the base of the telephone.
2. Loosen the screw fastening the
battery compartment cover using a
screwdriver and remove it from the
back of the phone.
3. Use the screwdriver to push at the
base of the cover’s catch and push
up to
fl ip open the compartment
cover.
4. Insert 4 AA batteries into the
compartment paying close attention
to the labelled polarities.
5.
Close the battery compartment
cover and secure with the screw.
Low battery:
If the batteries are low, the “Battery
Low” icon will appear in the upper left
corner and
fl ash. If the batteries are not
installed, the “Battery Low” icon will only
appear when the display is active while
the phone is off-hook.
Selecting a Location
The phone may be used on a desk or
mounted on a wall. Select a location
that meets the following requirements:
1. Near a telephone line wall jack.
2. Away from any electrical machinery,
appliances, and metal walls or
fi ling
cabinets.
10
Storing Numbers
1. Press [
Store
]. The display will show
“SAVE TO?”
2. Press either a one-touch memory
location (eg. [
M1
]) or [
DIR
], which ever
place you wish to store the number.
The memory location is displayed in
the display brie
fl y. Then the LCD will
display “ENTER NUMBER.”
3. Use the dial pad to enter the phone
number you are storing. Press [
▼ ]
or [
DELETE
] to remove a wrong
digit. Press [
Store
] when you are
satis fi ed with the number you are
storing.
4. The LCD will display “ENTER NAME.”
5. Use the dial pad to enter the name
(see chart below). Press [
▼ ] or
DELETE
] to remove a wrong letter.
Press [ ▲ ] to move the cursor to the
next character or to add a space
Press [
Store
] when you are
satis fi ed with the name you are storing.
Record locations of important speed
dial numbers on the memo log.
Note
: A maximum of 3 one-touch and
32 speed dial entries can be stored in
the directory.
Using the Speed Dial
Directory
Dialing out with directory memory:
1. Press [
Directory
]. The LCD will
display “DIR. ITEM” and the number
of memories stored in the directory.
2. Press [ ▲ ] or [ ▼ ] to move through
the directory list or enter the two digit
memory location using the dial pad.
3. Once you have found the number
you wish to dial, press [
DIAL/ENTER
],
press [
Handsfree
], press an unused
line key, or pick up the handset. The
phone will connect the line and dial out
the selected number.
4. To end the phone call, press the
active line key, press [
Handsfree
], or
return the handset to its cradle.
Using the One-Touch Speed
Dial Memory
Dialing out with one-touch memory
1. Press a memory key (eg. [
M1
]).
2. The telephone will connect the line
and dial out the stored number.
15
SPEED DIAL
INSTALLATION