MC DTC Series
– User manual
16 / 51
5.2 Card feeding
The input hopper (automatic card feeder) can hold a maximum of one hundred 0.76 mm thickness cards. A label inside the door
gives the instructions for correctly positioning and orienting magnetic stripe and smart cards
The card path can be selected from the driver to speed up card processing:
•
Front hopper
•
Rear hopper / reject bin (** not applicable for MC110)
•
Manual feeder (** not applicable for MC110 and MC210)
The output hopper at the front of the printer can hold a maximum of thirty 0.76 mm thickness cards.
5.1.1 Input hopper (automatic card feeder)
Open the hopper door as shown below to load the cards and close the door.
5.1.2 Front slot (manual card hopper)
The manual card feeder is always ready for use and is prioritized. It is suggested that it can be used when the job requires an
exception card to the ones loaded inside the input hopper.
Insert the card inside the slot as shown below.
Note
: contact chip cards to be inserted face up, magnetic stripe cards should be inserted with the magnetic stripe facing downwards
towards the right.
.
