Manual, Collision Sensor,SR‑82
Document #9610‑60‑1007‑08
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati‑ia.com
14
5.1 Periodic Lubrication Instructions
5.1.1 Cover Plate and Stem Disassembly
Note: Cleaning may be accomplished with a clean, dry rag. For more thorough cleaning, use
isopropyl alcohol.
1.
Remove the (4) socket head cap screws securing the cover plate assembly to the body using a
2.5 mm hex key (refer to
).
CAUTION:
Do not attempt to pry or wedge the cover plate assembly and
body apart. Doing so can damage the mating surfaces and may render the
parts unusable.
2.
Remove the cover plate assembly by carefully pulling it straight up and off of the body. This
may be difficult due to the close fit of the dowel pins used to align the parts. It may be necessary
to hold the unit up by the cover plate and lightly tap on the stem with a rubber or plastic mallet.
Note
: The dowel pins are pressed into the cover plate and are a slip fit into the body.
CAUTION:
The cover plate assemblies and stem assemblies are
factory‑assembled as matched parts. Do not allow either of these assemblies
to be mixed with those from other units.
Figure 5.1—Disassembly of Cover Plate
