ATI
Q46C2 2Electode Conductivity System
Part 2
– Analyzer Mounting
12
O&M Manual
Rev-H (6/19)
2.3
Panel Mount
Panel mounting of an AC powered monitor uses the panel mounting flange molded into the rear
section of the enclosure.
provides dimensions for the panel cutout required for mounting.
The panel mounting bracket kit must be ordered separately (part number 05-0094). This kit
contains a metal retainer bracket that attaches to the rear of the enclosure, 4 screws for attachment
of this bracket, and a sealing gasket to insure that the panel mounted monitor provides a water
tight seal when mounted to a panel.
The sealing gasket must first be attached to the enclosure. The gasket contains an adhesive on
one side so that it remains in place on the enclosure. Remove the protective paper from the
adhesive side of the gasket and slide the gasket over the back of the enclosure so that the adhesive
side lines up with the back of the enclosure flange. Once in place, you can proceed to mount the
monitor in the panel.
Figure 5 - Panel Cutout and Mounting
