Page 14
Remote Control Programming
The remote allows you to transfer a command from a button
on your source remote control (original equipment remote
control) to a button on the ATP7500 remote control. In the
CD, DVD, AUX, SAT, TV,VCR and CBL device modes, new
commands can be taught to any button except the LIGHT button.
The remote control provides distinct visual feedback with
LEDs (Light Emitting Diodes) that are located at the top left of
the remote control (Status LED) and under the Device buttons.
The Status LED at the top left of the remote operates in three
colors (red, orange and green). The Device buttons have a
red color LED behind them. These LEDs will assist you in
programming in the learning section of the remote control.
Learning a New Command
Select a Device mode in which you would like to teach the
new command. For example, if you wanted to learn a new
command to the
PREV CH
button in the TV mode on the
remote, you would select the
TV
Device button and then use
the instructions below to teach the new command to the
PREV CH
button.
Step 1. Press the Device button and the
SELECT
button
simultaneously, and hold until the orange Status LED
and the Device button turn on and remain lit.
Step 2. On the remote control, press the button that is to be
taught the new command. The orange Status LED will
begin to flash continuously. The Device LED will turn off.
Step 3. On the source remote control (the original remote
control), press and hold the button for the command
to be learned until the Status LED on the remote
turns green. Release the button on the source remote.
Step 4. Press the button on the source remote control, once
again to verify that the new command has been
learned correctly. The Status LED will flash green
twice and then turn to a steady orange color
indicating that the programming was successful.
The Device LED will turn on.
Repeat Steps 2 through 4 for any other buttons to be taught
in the Device mode selected in Step 1.
Step 5. Once you have completed learning new commands
to the buttons in the selected Device mode, you must
save the programmed information. Press and hold
the Device button and
SELECT
button simultaneously,
and hold until the orange Status LED flashes twice.
The Device button will turn off.
Please repeat for any other Device modes starting from Step 1.
All manuals and user guides at all-guides.com
