Athena A060-Mini, Инструкция по установке и эксплуатации

Страница: 15 / 27

Page 11 Wireless Communications
5 T
ERMINAL MANAGEMENT AND MONITORING FUNCTIONS
The A060-Mini
®
link is configured from the factory with default IP addresses as shown below. Use a PC or
laptop to change these defaults by connecting to the terminal with the appropriate IP. Every terminal is
labeled with its terminal type (A or B).
The factory default values are:
Terminal IP Address Subnet Mask Username Password
A 192.168.1.21 255.255.255.0 na na
B 192.168.1.22 255.255.255.0 na na
To communicate with the terminal, ensure that the IP address of the computer used is not allocated
automatically by a DHCP server. Configure the IP address of the computer manually (e.g. ip
192.168.1.100 with subnet mask 255.255.255.0). Ensure that your web browser is not using any proxy
server settings.
Note: The IP address settings have no influence on data connectivity. These settings are only needed to
access and monitor the terminal.
5.1 Web browser interface
A web browser can be used to access and change user defined settings on the
A060-Mini
®
link.
All information is contained on one screen that is divided into five sections
– Overview, Wireless Network,
System and Status.
5.1.1 Overview
This screen shows an overview of key link information including, but not limited to, its serial number,
version, mac address, temperature, and current status.
5.1.2 Wireless
The wireless screen is divided into setup and status.
Setup gives the Terminal type (A or B), transmit and receive frequencies and the transmit power. The
transmit power can be changed between four settings depending on the distance between terminals.
Make sure to click the ‘Apply’ button for changes to take effect.
Status shows the data rate, modulation type, link margin and receive power.
5.1.3 Network
The network configuration screen offers the option to change network settings if required. Link settings
which can be changed are IP Configuration (DHCP or Static), IP address, subnet, gateway, DNS, VLAN
and VLAN ID. The IP address and VLAN settings have no influence on data connectivity. The “Enable
VLAN” check box allows the A060-Mini
®
terminals to be accessed when the link is integrated into a VLAN
trunk. The VLAN ID needs to be set when the link is integrated into a VLAN trunk. Please click the Apply
button to save any changes made on this screen.
This screen also displays the terminal’s MAC address, MDI Setting and Network data-rate.