Athena A060-Mini, Инструкция по установке и эксплуатации

Страница: 12 / 27

Page 8 Wireless Communications
4 I
NSTALLATION
Owing to the small size and integrated design of the A060-Mini
®
link, its correct installation and setup is
relatively simple.
Nevertheless, when working on a roof, ladder, mast or staging, please take extreme care, observing all
facility and OSHA (or other applicable regulatory agency) required safety precautions.
4.1 Mount installation
4.1.1 Wall mount
The wall and mounting screws must be able to support a weight of 11 pounds (5 kg), taking into account
associated wind and potential ice loading factors.
Please note that the wall mount must be installed with the proper orientation as shown below.
4.1.2 Mast mount
• Ensure that the mast used has a diameter of between 50 mm to
115 mm (2” to 4.5”).
• Fasten the mast bracket onto the mast using the enclosed
stainless steel screws, nuts and washer (M6).
• Fasten the alignment bracket onto front part of the mast bracket
using the enclosed stainless steel screws, nuts and washer (M6).
Do not use zinc plated screws as these will corrode and endanger link
performance and safety to people and equipment.
4.2 Terminal installation
It is important to install the terminal on the bracket with the same
orientation (antenna polarization) at both ends of the link. The terminal
must be mounted on the bracket in such a way that the polarization
arrow points to the same direction at both ends of the link. The terminal
must be mounted on the bracket by using the enclosed stainless steel
screws (M6 x 12).
Do not use zinc plated screws as these will corrode and endanger link performance and safety to people
and equipment.