Athena 6075 series, Инструкция по эксплуатации, Страница: 19 / 39

2. .Range of Adjustments (Parameters)
All parameters are accessed by pressing the INDEX key. They
are
listed
in the order they are displayed when the lNDEX key is pressed.
The front panel of the Model 6075 contains a lower display of 5 digits
which displays the set point temperature, the other parameter values
and degrees F or C. The upper display consists of 4 digits which display
the process value or the parameter abbreviations; e.g. -A1- identifies
Alarm
1. As the INDEX key is pressed the second column abbreviations
appear in the upper display. To the right of the ENTER Key is an EXIT
Key labelled ‘SET POINT’ which allows the user to EXIT parameters 2
thru 16 back to parameter # 1 (set point). After changing a value the
ENTER Key must be pressed. This enters the new value in memory. If it
is not pressed and power is removed, the last value entered for that
parameter will be set up for that parameter.
DlSPLAYED
NUMBER CODE PARAMETER
RANGE
0 Process Temperature Zero to span of
unit ( º F or ºC)
1 Set Point Zero to span of
unit (ºF or ºC)
2 -A1- Alarm One Zero to span of
unit (ºF or ºC)
3
-A2-
Alarm Two Zero to span of
unit (ºF or ºC)
4
-rt- Rate/Reset (1:6 ratio) 0 to 255 Seconds
5
-HG-
6
-HC-
7
-CG-
8 -CC-
9 cd-
Heat Gain
Heat Cycle Time
Cool Gain
Cool Cycle Time
Access Code
(See Note 6)
(See Note 2)
0 to 120 Seconds
(See Note 7)
0 to 400
(See Note 2)
0 to 120 Seconds
(See Note 7)
0 to 255
(See Note 3)
-
-
1 to 400