ATH-Heinl M72Z, Руководство пользователя

Страница: 24 / 80

® Copyright by ATH-Heinl GmbH & Co. KG, 2019, All rights reserved / Misprint and technical changes reserved / Issue: 2019/02
- 24 -
Demounting of a tire
The guidelines of WdK (Trade association of the German rubber industry) must be observed
when demounting a tire.
Turn resp. adjust the clamped wheel in that way, so that the tire valve
is positioned approximately 10 cm before the mounting head.
Push down the tire bead on the opposite side of the mounting head.
Afterwards lift the tire with a tire lever over the mounting head. While
lifting the tire will slide into the drop centre of the rim and enables
therefore an easy and damage-free mounting.
Press the pedal for turning the turntable so that the clockwise rotation
can be started.
Hold thereby the tire lever still on the nozzle of the mounting head by
pressing it against the mounting head.
As soon as 1/3 of the tire bead was running over the rim flange there
should be enough free space to remove the tire lever.
Continue with the rotation until the complete tire is over the rim
flange.
If it is a tubed tire the tube should now be removed.
For levering out the lower tire bead lift the tire as far as it is at the
same height as the drop centre of the rim.
Then position the tire lever between tire and mounting head and lift
the tire directly under the mounting head.
Lever now the tire bead over the rim and start the rotation in the
same way as with the upper bead.