ATEN VS0801HB, Руководство пользователя

Страница: 20 / 31

Chapter 3. Operation
12
Switching the Display Source
You can switch the display source using either the panel pushbuttons, IR
remote control unit, or RS-232 serial controller:
Š
Panel pushbuttons
Press the
Port Selection Pushbutton that corresponds to the source you
wish to switch to. The corresponding Port LED lights green to indicate that
the source is selected.
Š
IR remote control unit
Aim the IR remote control unit at the VS0801HB and press the
corresponding
Port Selection Button . Alternatively, cycle through the
available sources by pressing the Port Up button to cycle forward (e.g.
from source 1 to 2), and the Port Down button to cycle backward (e.g. from
source 2 to 1).
Š
RS-232 serial controller
You can switch the display to a specific source by executing RS-232
commands. For detailed steps, refer to the
RS-232 Commands , page 15.
Note:
Š
Make sure to use the IR mote control unit within the effective range (6 m).
Š
For optimum performance, make sure there is a clear line-of-sight between
the remote control unit and the connected IR receiver on the VS0801HB.