ATEN VE829, Руководство пользователя

Страница: 39 / 42

Appendix
31
Poor picture quality or
intermittent video
Š
Check if the video resolution on your HDMI display is set
to 1080p, 1080i, 720p, 576p, or 480p resolution. Refer to
Video and Audio Format Supported , page 29.
Š
Check that the distance between the Transmitter and
Receiver does not exceed 100 feet.
Š
Solid structures (walls, panels, beams) between the
Transmitter and Receiver can affect signal quality. Con-
sider installing the units with the least amount of barriers
between them.
No audio
Š
Check your display’s volume is not set to Mute.
Š
Check your input source device’s audio volume has
been enabled. Adjust the volume accordingly.
Š
Ensure the bit rate of audio from the source device is
supported (refer to page 29).
IR Remote Control
cannot control input
source device.
Š
Check where is IR sensor is located on the input source
device. Make sure that the IR Blaster Extender Sensor is
close aligned to the input source device’s IR sensor.
Š
Change the IR Blaster Extender frequency to meet the
input source device’s requirement. See
IR Blaster
Extender Cable Setup , page 13.
No 3D video output
Š
Check that the connected HDMI displays on the Trans-
mitter and Receiver can support 3D video format.
Š
Turn off 2D HDTV mode on your HDMI display (that sup-
ports 3D video format) and reboot the display. Set the
input source device to 3D video format output for the 3D
display.
Š
Check the video output setting of the input source device
(ex. Blu-ray Disc, PS3..etc.) supports 3D video format.
Š
Ensure the 3D format timing from the input source
device is supported (refer to page 29).
Problem Resolution