[28]
Please connect the 0-‐20mA Sensor
according to the Connection Diagram below,
while the instrument is OFF
Please follow the steps below to
calibrate the 0-‐20mA Output Sensor
QUICK 0-‐20mA OUTPUT SENSOR CALIBRATION GUIDE
1) Press and hold button, and
while holding button
press button at the same time
2) Press button
prog
˝Inpvt
sensor
3) Press 2 times
button
0-20nA
5) If you don’t see “
0-20nA
”,
use buttons until you see it,
then press button to save
4) If you see “
0-20nA
” in the display,
press button to save, and
go to step (6)
9) Press 2 times button
8) Press button
6) Press 2 times button
˝Inpvt
7) Press 2 times button
˝CaLIb
SCL-Lo
10) Use buttons until
you see “
0
” in the display
11) If you see “
0
” in the display,
press button to save
in the display
0
19) Press 2 times button, to go back to Operating Mode
18) Press button to save
14) After you enter full range output in the display,
press button to save
SCL-HI
CAL-Lo
12) Press 2 times button
100
13) Enter Sensor’s full range output value here,
using buttons (e.g. 10bar, 500bar etc.)
15) Press 2 times button
avtoCL
16) Press button
OFF
17) Press button
On
