Atek 1-10KVA, Руководство пользователя, Страница: 19 / 40

１６
10. Installation
10.1 Unpacking and Inspection
1) Unpack the packaging and check the package contents. The shipping package
contains:
l
A UPS
l
A user manual
l
A communication cable
l
A battery cable (for 6KS/10KS only)
2) Inspect the appearance of the UPS to see if there is any damage during
transportation. Do not turn on the unit and notify the carrier and dealer immediately if
there is any damage or lacking of some parts.
10.2 Input and output power cords and protective earth ground installation
1. Notes for installation
1) The UPS must be installed in a location with good ventilation, far away from water,
inflammable gas and corrosive agents.
2) Ensure the air vents on the front and rear of the UPS are not blocked. Allow at least
0.5m of space on each side.
3) Condensation to water drops may occur if the UPS is unpacked in a very low
temperature environment. In this case it is necessary to wait until the UPS is fully
dried inside out before proceeding installation and use. Otherwise there are hazards
of electric shock.
2. Installation
Installation and wiring must be performed in accordance with the local electric code
and the following instructions by professional personnel.
For safety, please cut off the mains power switch before installation. The battery
breaker also needs to be cut off if it is a long backup time model (
“
S
”
model).
1) Open the terminal block cover located on the rear panel of the UPS, please refer
to the appearance diagram.
2) For 6K(S) UPS, it is recommended to select the UL1015 10AWG(6mm
2
) wire or
other insulated wire which complies with AWG Standard for the UPS input and
output wirings.
3) For 10K(S), it is recommended to select the UL1015 8AWG(10mm
2
) wire or
other insulated wire which complies with AWG Standard for the UPS input and
output wirings.