Component Checklist
Primary Arm 230mm (x1)
75/100mm VESA
Plate (x1)
Cover
Plate (x1)
Installation Procedure
! IMPORTANT - Install Telehook Multi as per Installation Instructions.
!
Telehook Multi supports Displays from 12” (30cm) to 30” (76cm) weighing up to 18kg (39lbs).
!
The Manufacturer accepts no responsibility for incorrect installation.
Bits Box
Installation Instructions
TELEHOOK
12/30 Multi
Wall
Bracket (x1)
200mm VESA
Plate (x1)
M8 Nyloc (x1)
M8 Cap Screw (x1)
14 Gauge Coach Screws (x2)
6mm Allen Key (x1)
M8 Square
Neck Bolt (x2)
Push In Clips (x3)
M4 x 10mm
Screws (x6)
Yoke (x1)
B Choose your Mounting Option
M8x 115mm Bolt (x1)
Secondary Arm
200mm (x1)
A Check Components
Check you have received all parts against the Component Checklist and Bit Bag above.
Double Sided
Bush (x1)
Select which mounting option is best suited for your application.
Note that the Telehook 12-30 Multi comes packaged as the Swing Arm by default. (Option 1.)
Steel
Washers (x2)
One Sided
Bush (x4)
Plastic
Washers (x2)
M8 Nyloc’s (x2)
Swing Arm
(x1)
Swing Arm Components
Option 1: Swing Arm
Wall
ISOMETRIC VIEW
Follow Steps; C, D, F & J
Nylon Anchor Plugs (x2)
4mm Allen Key (x1)
M4 x 12mm
Screws (x6)
M4 x 16mm
Screws (x6)
M6 x 12mm
Screws (x6)
C.1.
C.2.
2x14 Gauge
Coach Screws
Wall Bracket
Cover Plate
Wall Bracket
Cover Plate
2x14 Gauge
Coach Screws
2x Nylon
Anchor Plugs
Stud
Wall
Material
Masonry Wall
C Installing the Wall Bracket
Option 3: Wall Mount
Wall
Options 1 & 2 (Swing Arm & Articulated Arm)
Follow Steps; G, H, I, & J
C.1 Mounting to a timber stud wall
- Position Wall Bracket vertically on the wall and mark the 2
mounting holes. (Use a Spirit Level)
- Drill 2x50mm(2”) holes using a 3mm(3/16”) drill bit.
- Secure the Wall Bracket using the supplied 14 Gauge Coach
Screws.
- Attach the Cover Plate as shown in diagram C.1.
C.2 Mounting to a masonry wall
- Position the Wall Bracket vertically on the wall and mark the 2
mounting holes. (Use a Spirit Level)
- Drill holes using an 8mm masonry drill bit.
- Secure the Wall Bracket using the supplied 14 Gauge Coach
Screws and Nylon Anchor Plugs.
- Attach the Cover Plate as shown in diagram C.2.
Option 2: Articulated Arm
Wall
Follow Steps; C, E, F, & J
NOTE! You must remove the Wall Bracket from the Swing Arm before Installing
Horizontal Correction of Display
Adjust Angle
Loosen
Screw
If the display does
not sit horizontally,
loosen the screw
shown on the
back of the yoke
using the 4mm
Allen Key.
Re-tighten screw
firmly when
display is
positioned
horizontal.
4mm Allen Key
