Step 2. Mount Pole Assembly (cont.)
Step 3. Mount Notebook Tray Arm
2.4
Remove the M8 x 16mm Socket Head Countersunk
Screws to release the Desk Clamp Bracket.
2.3
The Desk Clamp bracket can be repositioned to suit different mounting
surface thicknesses. The maximum mounting surface thicknesses supported
are listed below from the Top to Middle and Bottom Screw Holes.
T
T
M
M
B
B
M8 x 16mm Socket Head
Countersunk Screw
5mm Allen Key
Desk Clamp Bracket
Pressure Plate
Table Top
M8 x 16mm Socket
Head Countersunk
Screw
M10 Desk Clamp Screw
5mm Allen Key
5mm Allen Key
5mm Allen Key
Notebook Tray &
Arm Assembly
Pole Top Cap
2.5
Place in desired
location.
If you need to reposition the desk clamp bracket or you have no
access to the rear of your table continue to
Step 2.4
.
If you DO NOT need to reposition the desk clamp bracket and
you have access to the rear of your table skip to
Step 2.7
.
2.6
Reattach Desk
Clamp Bracket.
2.7
After positioning
your Pole Assembly,
screw Pressure Plate in
and Tighten Firmly.
3.1
Unlock Handgrip
and raise so that the
Handgrip Tab protrudes.
3.2
Slip the Notebook Tray &
Arm Assembly over the Handgrip
Tab and then onto the Pole.
3.3
Slide the Notebook Tray & Arm
Assembly and Handgrip down the
pole before locking the Handgrip at
the desired height.
Desk Clamp Bracket
Top
0 - 32mm (default)
Middle
7 - 47mm
Bottom
22 - 62mm
Top
29 - 69mm
Middle
43 - 84mm
Bottom
59 - 99mm
3.4
Insert Pole Top Cap into Pole. This
is also where the Allen Key is stored.
