AWM-X40 Page 2 of 3
remove label
but ensure
alignment
insert stays
in place.
Alignment
insert
Ensure channels
without guide
marks are aligned
on both posts.
Alignment
insert
Alignment
insert
If alignment insert falls out
,
reposition it as shown above.
Ensure arrow on alignment
insert points away from the
post channel without guide
marks on both posts.
1.
Screw Threaded Rods into Post
2.
Stack Post
1.1
Remove post cap and label on both posts.
NOTE
Rods can be
finger tightened
2.1
Align the second post with
its alignment insert facing the
tips of the rods. Then feed the
threaded rod into the holes of
the second post.
2.2
Slide the post down the rods until it sits
flush against the top of the lower post.
1.2
Screw threaded rods into the end of one
post that has the alignment insert.
IMPORTANT
Check Desk Fixing
(fixing sold separately)
AWM-FH
AC-GC
Atdec Custom
Rail Plate
When stacking posts only the following
heavy duty fixings can be used:
i
!
1.1
If lower post is already installed, the
fixing on the lower post may need to be
changed. Follow the installation guide
provided with your heavy duty fixing
to attach it to the post and fit it to the
worksurface.
NOTE:
Posts can be stacked
before or after attaching
to desk fixing.
STACKING INSTRUCTIONS
