AWM-X40 Page 3 of 3
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©
20201030
Remove two
threaded rods
using an 8mm
(5/16”) wrench.
If tips come off the
end of the rods
screw them back
together before
storing for later use.
Unscrew two nuts
using 10mm (3/8”)
wrench.
Ensure the two
alignment inserts
stay in the ends
of both posts.
1.
Remove Stacked Post
2.
Remove Threaded rods
UNSTACKING INSTRUCTIONS
1.1
Remove cap and all monitor
arms from the stacked post.
2.1
Unscrew two threaded rods using
an 8mm (5/16”) wrench.
1.2
Remove nuts and washers
from top of post.
2.2
Fit post cap
1.3
Slide stacked post up off the
threaded rods.
2.3
Store parts together for later use.
Tighten two nuts
firmly using 10mm
(3/8”) wrench.
Ensure the post join area
remains well aligned
while tightening the nuts.
3.
Fasten Posts Together
3.1
Screw together the posts using
the provided nuts and washers.
3.2
Fit post cap
Follow post and
arm installation
guides to complete
installation of your
mounting solution.
Installation Complete
