AWM-AD Page 2 of 4
1.
Set arm rotation to 180° (optional)
2.
Fit arm onto Base or Post Clamp (sold separately)
Note:
Check the
arm rotation is
smooth after
tightening.
2.1
Push arm onto shaft.
2.2
Ensure arm is fully pushed onto shaft.
2.3
Tighten joint screw.
1.1
On the Base or Post
Clamp (sold separately)
Remove plastic sleeve.
1.2
Remove rotation ring.
1.3
Place rotation ring in the
desired position.
Post Clamp Ring Position
When setting post clamp rotation,
orientate the ring depending on what
post channel the arm will be attached
to. The tag on the ring should always
face towards the user.
180°
360°
OR
Default
Position
Flipped
Position
Tag
1. Press
2. Lift
3.2
Attach VESA head onto monitor with
provided screws.
3.
Attach VESA head to monitor
100mm
75mm
100mm
75mm
Flush
Too long
Too short
Spacer
5mm
12mm
3.3
Be sure to use correct screw length
3.1
VESA mounting compatibility
100mm
75mm
100mm
75mm
Flush
Too long
Too short
Spacer
5mm
12mm
Note:
For other sizes, use a suitable
adaptor plate (sold separately).
Note:
Spacers may
be required
for curved,
recessed
or uneven
monitor
surfaces.
4.
Mount monitor on arm
Monitor arm
4.2
Ensure that the VESA head sits flush within
the monitor arm. There should be
no
gap.
4.1
Insert VESA head into the monitor arm
4.3
Push the lever down to secure
it to the arm assembly
Gap
No Gap
