AD-WM-5060 Page 4 of 4
5mm Hex Key
(Not Supplied)
I
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©
20211014
8. Hook the Display onto the Arm Assembly
8.1.
Angle the display and hook the upper nuts on the
rear of the Display Bracket to their corresponding
slots on the Arm Assembly. See Step 2.1.
This should be completed by two people.
8.2.
Securely tighten the upper nuts on the
Display Bracket and replace the lower nuts
removed in Step 2.2 using Spanner
G
.
+/- 3 °
+2 / -15 °
9.1. (OPTIONAL)
To vary the force required to move
the the display - use a 5mm Hex Key to tighten or
loosen the Hex Screw at the bottom of the arm.
Display Tilt
Display Level / Rotation
9.2.
To complete installation, use Arm Joint Cap
I
to conceal the the
Arm tension screw.
9. Adjust the Arm Joint tension
ADJUSTMENTS
NOTE:
For heavier displays, you may need to tighten the nut opposite
the Lever using a Socket Wrench tool (not supplied).
WARNING:
Only loosen, do not remove the four nuts.
NOTE:
• Factory setting should suit a majority of installations.
