AD-WM-5060 Page 3 of 4
5. Attaching Covers to Mount
4. Attaching Mounting Plates
4.3
4.2
4.1
4.1.
Position Security Plate
D
inside the upper Wall Plate rail, behind the Arm
Assembly. Ensure the holes on the Arm Assembly, Wall Plate and Security Plate
are aligned.
4.2.
Screw the two Security Screws
E
through the Arm Assembly
A
and Wall Plate
B
into the Security Plate, using Washers
F
between the screws and the assembly.
4.3.
Repeat with the second Security Plate
D
and the lower holes on the lower half
of the Arm Assembly.
5.1.
Conceal wall plate fasteners using
Plastic Covers
C
. Gently apply even
pressure until they snap in place.
7. Attach the Display Bracket to the Display
6. Adjust the width of the Display Bracket
6.1.
Loosen the four nuts at each corner of the display
bracket using Spanner
G
or a quality socket wrench tool.
6.2.
Adjust the spacing of the
vertical brackets to suit your
display and tighten the four
nuts before proceeding.
NOTE:
• Always use a multi-washer.
• Use the shortest combination of spacers (if necessary)
ensuring the display is not loose and screws are not forced
too deep into the display.
NOTE:
• Ensure vertical brackets are equispaced from the centre.
