ATD Tools ATD-3425, Руководство пользователя

Страница: 4 / 7

EXPERTS IN VACUUM PUMPS
outlet.
·
When unplugging the pump, pull the plug. Don’t unplug unit by pulling on the wire.
·
Keep electrical cord free from all shop equipment, and do not let pump hang by
power cord
·
Don’t use damaged plug or outlet.
·
Don’t plug or pull out the plug with wet hands.
·
Don’t plug unit in, unplug unit or use switch if there are any flammable or explosive
gases present.
·
Always Unplug unit before disassembling.
6. Installation
·
When in use, the pump should be horizontal and should be positioned where it is dry,
ventilated and free of dust and other contaminants.
·
In order to ensure proper air flow, you must maintain a clearance around the pump of
at least 5 cm (2 inches).
·
To permanently mount the vacuum pump, remove the rubber pads from the bottom
of the base, and use the existing threaded holes to mount unit. Connect with M4x12
screw and M4 nut. When permanently mounting this pump, be sure to maintain
proper clearances around the unit, especially at the air intake in the end of the vane
shell.
·
If a special electromagnetic valve is needed, it can be installed on the gas inlet.
7. Troubleshooting