ATD Tools ATD-10556, Инструкция по эксплуатации

Страница: 3 / 16

3
Important Safety Rules
DANGER!! Failure to observe any of the following instructions could result in severe personal
injury to tool user and bystanders or cause damage to tool and property!
WARNING!
– Read, understand and observe all instructions in this manual before
using or operating the tool for which it is written and supplied. Ensure that
anyone who is to use the tool has read and understood the instructions provided.

Always wear eye protection that complies with a recognized standard (CSA or ANSI).

Wear a mask or respirator when dust is generated.

Keep bystanders out of the work area while operating the tool.

WARNING! Always ensure that the work area is clear of any flammable
materials, liquids or gasses, because the use of this tool may create sparks.

Tighten grinding wheel lock nuts, securing bolts and all clamps and guards.

During each start-
up, stand to one side of the grinder and switch it „On‟. Let the grinder operate at
full speed for approximately one minute so that any undetected flaws or cracks will become
apparent.

Keep guards in place and working properly.

Keep hands clear of grinding wheels.

Never reach behind or beneath the grinding wheels.

Unplug from power supply before adjusting or servicing. The grinding wheels continue to rotate
after the tool is switched off. Always allow wheels to stop before adjusting or servicing.

To avoid electric shock, DO NOT use in damp conditions or expose to rain.

When fitting a new grinding wheel, always check that the stated maximum RPM meets or
exceeds that stated on the grinder. Also check the new wheel for damage, such as flaws or
cracks. If the wheel appears satisfactory, fit it to the grinder.

When a new grinding wheel has been fitted, stand to one side of the grinder and switch it „On‟.
Let the grinder operate at full speed for approximately one minute so that any undetected flaws or
cracks will become apparent.

Use only accessories that are recommended by the manufacturer for your model.

DO NOT attempt to cut anything with the grinding wheel.

Grounded tools must be plugged into an outlet that has been properly installed and grounded in
accordance with all local codes and ordinances. Never remove the grounding prong from the plug
or modify it in any way. Do not use adaptor plugs. If in doubt as to whether the outlet is properly
grounded, consult a qualified electrician.

Do not use the tool when tired or under the influence of drugs, alcohol or medication.

Do not wear loose clothing or jewelery. Keep hair tied back.

Ensure the power switch is off prior to plugging in the tool.

WARNING! Replace cracked grinding wheels immediately.

Do not overtighten spindle nuts.

Adjust tool rests whenever necessary to maintain a distance of 1/8” (3.2 mm) from the
grinding wheel.

Service on these tools should only be performed by an authorized, qualified technician.