AXE2G4AN User Manual
www.atcom.cn
Email: [email protected]
3
Chapter 2 Hardware Introduction
GX01N: GSM module, one GX01N supports one GSM channel.
AX210S: FXS module, it supports two FXS ports.
AX210X: FXO module, it supports two FXO ports.
CON1: 4 pin power connector.
JP4: used for selecting the way of power feeding, It will be jumped to right in default.
Hole: used for fixing the line which connect the GX01N to antenna.
Antenna: the antenna in the picture above is omnidirectional, the model is TS01
Attention: In order to enhance the GSM signal in some hard environment, except the Antenna in
the illustration above, ATCOM can also provide one other type of antenna(TL01)
which has long cable(about one meter long) and can be connected to outside.
RJ45: used for connecting a splitter to the card, the splitter supports four RJ11 ports and one RJ45
port.
LED-A: used for checking if the FXS/FXO module is detected or not. When the FXS/FXO ports
are detected correctly, the LED will be on.
LED-G: used for checking if the GSM module is detected or not. When the GSM ports are
detected correctly, the LED will be on.