AXE2G4AN User Manual
www.atcom.cn
Email: [email protected]
7
Chapter 5 Software Configuration
1. Please run the command: “cat /proc/interrupts” to check if the AXE4GN driver has been
loaded successfully. And users should get one line with
axe4gn
like the following.
16:
42079
10824611
IO-APIC-fasteoi
axe4gn
If users can not get the above message, please try to power off the server and re-plug the
asterisk card into another PCI-E slot.
2. Please run the “dahdi_genconf” command to configure the “/etc/dahdi/system.conf” file and
generate “/etc/asterisk/dahdi-channels.conf” file.
[root@localhost ~]#
dahdi_genconf
It will not show anything if the command runs successfully. After doing that, the
“/etc/dahdi/system.conf” file will be created as the following configuration.
# Autogenerated by /usr/sbin/dahdi_genconf on
# If you edit this file and execute /usr/sbin/dahdi_genconf again,
# your manual changes will be LOST.
# Dahdi Configuration File
# This file is parsed by the Dahdi Configurator, dahdi_cfg
# Span 1: WCTDM/6 "ATCOM AXFSO Board 7" (MASTER)
fxoks=1
echocanceller=mg2,1
fxoks=2
echocanceller=mg2,2
fxsks=3
echocanceller=mg2,3
fxsks=4
echocanceller=mg2,4
# Span 2: AXGSM/0/2 "ATCOM GSM/WCDMA 0"
#gsmspan=2,1,0,ccs,ami
# termtype: gsm
bchan=3
hardhdlc=4
echocanceller=mg2,1
# Span 3: AXGSM/0/3 "ATCOM GSM/WCDMA 0"
#gsmspan=3,1,0,ccs,ami
# termtype: gsm
bchan=5
hardhdlc=6
