1
I N S T A L L A T I O N
Standard
electrical
outlet
Table/Desk Installation
Wall Installation
Strain-relief
groove
Power cord
Long telephone line cord
Modular
telephone
jack
Standard
electrical
outlet
Modular
telephone
jack
Short
telephone
line cord
Power cord
base. Slide the base down onto the knobs until it locks
into place.
6
Charge the handset battery.
Place the handset face up or face down in the base.
The CHARGING light on the base goes on to show the
handset is in the right position to charge the battery.
For best battery performance, charge the battery for at
least 12 hours the first time. After the first charge, the
battery will quick-charge in only six hours.
7
Check for dial tone.
After the batteries are charged, pick up the handset.
Check for a dial tone by pressing
P
; you should
hear a dial tone.
8
Set the dial mode.
If you have touch tone service, the phone is ready to
use as soon as the batteries are charged.
If you have dial pulse (rotary) service, you’ll need to
change the dial mode. When the phone is off, press
P
,
G
,
# # # 3
to set the dial mode to
Dial Pulse. To return to touch tone dialing (with touch
tone service), press
P
,
G
,
# # # 8
.
Belt Clip
If you wish, you can attach the belt clip to the cordless
handset, following the illustrations below. (The handset
cannot be charged in the face-up position if the belt clip
is attached.)
The instructions below are for both table and wall
installation.
1
Choose a spot near an electrical outlet and a
telephone jack.
This phone requires a modular telephone jack and a
standard electrical outlet (110v AC) not controlled by
a wall switch.
2
Install the handset battery.
(For an illustration of battery installation, see BATTERIES.)
•
Remove the battery cover by pressing on the
indentation and sliding downward.
•
Plug the battery pack connector into the handset,
and place the battery pack and wires into the
compartment.
•
Replace the battery cover by sliding it on its track
up over the battery compartment until it snaps
firmly into place.
3
Connect the telephone line cord.
Plug one end of the telephone line cord into the jack
on the back of the base (see illustration above). Plug
the other end of the line cord into a modular jack.
Make sure the plugs snap firmly into place. (If you are
wall mounting the phone, use the short line cord, and
press the excess cord into the groove on the bottom
of the base.)
4
Connect the power cord.
Plug the power adapter into the jack labeled
POWER
on the back of the base. Loop the cord through the
strain-relief groove, and press the cord into the groove
on the back of the base. Plug the AC adapter on the
power cord into an electrical outlet.
NOTE
: Connect power to the base unit before placing the
handset in the cradle.
5
Mount the base on the wall.
(WALL MOUNTING ONLY)
Hold the base so the mounting knobs on the standard
wall jack will fit into the holes on the bottom of the
To Remove
To Attach
