38
Appendix
In case of difficulty
If you have difficulty with your phone, please try the suggestions below. For Customer
Service, visit our web site at
www.telephones.att.com
, or call 1 800 222–3111.
Telephone does
not work at all
•
Make sure batteries are installed and charged correctly (see page 7).
•
Make sure the AC adapter is plugged into an outlet not controlled by
a wall switch.
•
Make sure the telephone line cord is plugged firmly into the base unit
and the modular jack.
•
Make sure the base antenna is fully upright.
•
If these suggestions do not work, unplug the base, remove and re-
insert the batteries, then place the handset in the base to re-initialize.
"Check battery"
or "Warning! Use
Rechargeable
Batteries Only"
is displayed on
screen
•
Non-rechargeable batteries have been installed. They must be
removed immediately and replaced with rechargeable NiMH batteries
(see page 7).
•
Rechargeable batteries have been installed but may be old or need to
be replaced. Remove and re-install the batteries and use normally
until fully discharged then let them fully recharge in the handset or
base.
•
If the above measures do not correct the problem, your batteries
should be replaced (see page 7).
Phone does not
ring
•
Make sure the ringer is on (see pages 14-15).
•
Make sure the telephone line cord and AC adapter are plugged in
properly (see page 6).
•
Make sure the base antenna is fully upright.
•
Move the handset closer to the base.
•
You might have too many extension phones on your telephone line to
allow all of them to ring. Try unplugging some of them.
If you hear
noise or
interference
during a call
•
Make sure the base antenna is fully upright.
•
You may be out of range. Move closer to the base.
•
Appliances plugged into the same circuit as the base can cause
interference. Try moving the appliance or base to another outlet.
•
The layout of your home or office might be limiting the operating
range. Try moving the base to another location, preferably on an
upper floor.
•
If the buttons don’t work, try placing the handset in the base for at
least 15 seconds.
•
Disconnect the base from the modular jack and plug in a corded tele-
phone. If calls are still not clear, the problem is probably in your
wiring or local service. Call your local telephone service company.
91-5635-40-00.E2600B.RO.qxd 02/13/1950 19:21 Page 38
