Atag OX6411, Инструкция по эксплуатации

Страница: 13 / 36

• If you have nonstick accessories, do not
clean them using aggressive agents,
sharp-edged objects or a dishwasher. It
can destroy nonstick coating.
Stainless steel or aluminium appli-
ances:
Clean the oven door with a wet sponge
only. Dry it with a soft cloth.
Do not use steel wool, acids or abra-
sive materials, as they can cause dam-
age to the oven surface. Clean the
oven control panel with the same pre-
cautions.
Cleaning the door gasket
• Regularly do a check of the door gasket.
The door gasket is around the frame of
the oven cavity. Do not use the appliance
if the door gasket is damaged. Contact
the Service Centre.
• To clean the door gasket, refer to the
general information about cleaning.
Shelf supports
You can remove the shelf supports to clean
the side walls.
Removing the shelf supports
1. Pull the front of the shelf support away
from the side wall.
2
1
2. Pull the rear end of the shelf support
away from the side wall and remove it.
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of
electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or de-
activate the circuit breaker.
Put a cloth on the bottom of the oven
to prevent damage to the oven light
and glass cover.
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
1. Turn the glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an ap-
plicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4. Install the glass cover.
13