Instructions for assembly
50
GB
NOTE
There is a risk of breakage if the induction hob is
canted or subjected to stress during installation!
Flush installation
Glue the sealing tape onto the corner of the
supporting edge of the worktop so that no silicone
adhesive can be pressed under the hob.
Place the hob into the worktop cut-out without any
adhesive and align it. Use shims if necessary.
Fill the gap between the hob and the worktop with
heat-resistant silicone adhesive.
Important
Silicone adhesive must not get under the support
surface of the hob. If this occurs it will not be
possible to remove the hob again at a later stage.
No liability will be assumed in the case of failure to
observe these instructions.
7.4 Variable installation possibilities:
Overlying installation
Dimensions in mm
7.5 External dimensions
overlying
fl ush
Kit
Tape
Содержание HIDD8471LV
