Atag HIDD8471E, Инструкции по использованию и установке

Страница: 38 / 116

Operation
38
GB
4.10 Permanent pan recognition
If the hob has permanent pan recognition, a cooking setting can
only be switched on via the sensor
fi eld after a pan has been
detected on the hob and the power display shows 0.
4.11 Operating the keys
The controls described here expect the pressing of a (selection)
key to be followed by the pressing of a subsequent key. The next
key will need to be pressed within 10 seconds, otherwise the
selection will be deleted.
4.12 Switching on the hob and cooking zones
1. Press the ON/OFF key (approx. 1 sec.) until the power
setting 0 appears and a short signal will sound. The controls
are ready for operation.
The permanent pan recognition recognizes on which cooking
zone a pan is set up and shows a 0 in the corresponding
power setting display.
2. Use the power setting display (as a key) to select a cooking
zone. The stand-by dot of the cooking zone selected will light
up.
3. The touch control must be activated immediately
afterwards. A power setting will be switched on.
.......left Power setting 0.
.......center Power setting 5.
.......right Power setting P*
See the section on Worth knowing about the slider (sensor
fi eld)
Press the respective sensor fi eld to change a
power setting or to switch on an additional cooking zone.
Important: the stand-by dot of the cooking zone selected must
light up.
4. Immediately put cookware suitable for induction cooking onto
the cooking zone. The pan recognition device will activate the
induction coil. The pot or pan will be heated up.
As long as no cooking pot is placed onto the cooking zone,
the display will alternate between the power level set and
the symbol . If no pot is placed on the cooking zone it will
switch o
ff after 10 minutes for reasons of safety. Please refer
to the Section on pan recognition.
4.13 Switching o ff a cooking zone
Use the power setting display (as a key) to select a cooking
zone. The stand-by dot of the cooking zone selected must light
up.
5. a) Press the sensor
fi eld on the far left or
b) drag your fi nger to the left across the touch control
to reduce the power setting to 0.
4.14 Switching o ff the hob
6. Press the ON/O ff key of the hob . The hob will be switched
o ff , irrespective of any settings.
Please note:
The hob will switch o
ff automatically after 10 seconds when all
the cooking zones are switched of manually (power setting 0)
and no key/sensor
fi eld is pressed afterwards.
* The Power boost function is activated immediately. See the
section on Power setting.
Suitable for induction cooking
Stand-by dot