50
COMPUTERFUNCTION
C. SET THE TIME
Rotate
MODE
to set the desired
TIME (1:00 TO 99:00)
and
press
MODE
to confirm.
NOTE for TIME:
Count Up: If a target time was not selected,
TIME
will count up from 0:00 to
maximum 99:59 minutes.
Count Down: If you have set the target time
(1:00 TO 99:00; 1 MINUTE
INCREMENT)
, the console will count down from that selected target time down to
0:00.
D. SET THE DISTANCE
D. SET THE DISTANCE
Rotate
MODE
to set the desired
DISTANCE (1.0 TO 99.0 KM/MILE)
and
press
MODE
to
confirm.
NOTE for DISTANCE:
Count Up: If a target distance was not selected, this would measure the total distance
from 0.00 to 99.9 km/mile.
Count Down: If you have set the target distance
(1.0 TO 99.0; 1 KM/MILE
INCREMENT)
, the console will count down from that selected target distance down
to 0.
E. SET THE CALORIES
Rotate
MODE
to set the desired
CALORIE (10 TO 990 CAL)
and
press
MODE
to confirm.
NOTE for CALORIES:
Count Up: If a target calorie was not selected, this would measure the total calories
from 0 to 9999 cal.
Count Down: If you have set the target calorie
(10 TO 990; 10 CAL INCREMENT)
,
the console will count down from that selected target calorie down to 0.
F. SET THE PULSE
F. SET THE PULSE
Rotate
MODE
to set the desired
PULSE (30 TO 230 BPM)
and
press
MODE
to confirm.
NOTE for PULSE:
Warning Reminder:
If you have set the target pulse
(30 TO 230 BPM (Beats Per
Minute; 1 BPM INCREMENT)
and console buzzer will beep when actual heart rate
is over the target value during workout.
G. START EXERCISE
G. START EXERCISE
a. Press
START/STOP
to begin your exercise.
b. During workout, you can rotate
MODE
to select the torque/tension level (from 1 to 32
levels).
c. During workout, press
MODE
to see each current workout value (
SPEED
,
RPM
,
TIME
,
DISTANCE
,
CALORIES
,
WATT
,
PULSE
).
NOTE for HEART RATE:
You must place both of your hands on the
Pulse Sensors
located on the
Handlebar
.
Your pulse will be displayed approximately few seconds after the heart symbol
“ ”
is
displayed.
If you do not place your hands correctly and a few seconds pass without a pulse
input, the console will turn off the pulse circuit and then display an error message
“
P
”
.
Place your hands back on the
Pulse Sensors
correctly, the pulse readout will appear
again.
Содержание RA6 O Series
Страница 1: ...BENUTZERHANDBUCH MANUAL RA6_O VERSION L BS www AsVIVA de Produktinfo ...
Страница 6: ...6 EXPLOSIONSZEICHNUNG ...
Страница 36: ...36 EXPLODED DIAGRAM ...