30
ASUS P/I-P65UP8 User’s Manual
III. INSTALLATION
(Connectors)
III. INST
ALLA
TION
13. SMI Suspend Switch Lead (SMI)
This allows the user to manually place the system into a suspend mode or “Green”
mode where system activity will be instantly decreased to save electricity and
expand the life of certain components when the system is not in use. This 2-pin
connector (see the figure below) connects to the case-mounted suspend switch.
If you do not have a switch for the connector, you may use the “Turbo Switch”
since it does not have a function. SMI is activated when it detects a short to
open moment and therefore leaving it shorted will not cause any problems. May
require one or two pushes depending on the position of the switch. Wake-up can
be controlled by settings in the BIOS but the keyboard will always allow wake-
up (the SMI lead cannot wake-up the system). If you want to use this connector,
“Suspend Switch” in the Power Management Setup of the BIOS SOFTWARE
section should be on the default setting of Enable.
14. ATX Power Switch / Soft Power Switch (PWR SW.) (ATX Power Req.)
The system power can be controlled by a momentary switch connected to this
lead. Pushing the button once will switch the system between ON and OFF.
The system power LED shows the status of the system’s power.
15. Reset Switch Lead (RESET)
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch This is a preferred
method of rebooting in order to prolong the life of the system’s power supply.
16. System Power LED (PWR.LED) or (TB.LED)
This 3-pin (PWR.LED) or 2-pin (TB.LED) connector connects to the system
power LED, which lights when the system is powered on and blinks when it is in
sleep (suspend) mode.
17. Keyboard Lock Switch Lead (KEYLOCK)
This 2-pin connector connects to the case-mounted key switch to allow key-
board locking.
18. Speaker Connector (SPEAKER)
This 4-pin connector connects to the case-mounted speaker.
System Panel Connectors
R
PLED#
Ground
PWRBT#
*
Requires an ATX power supply.
KLock#
+5 Volts
SPKR
Keyboard Lock
Speaker
Connector
Power LED
Ground
+5 Volts
Reset SW
SMI Lead
ATX Power
Switch*
ExtSMI#
ResetCon
Ground
Ground
Ground
Ground
+5 Volts
Ground
Power LED
