Asus AP5000, Руководство по установке, Страница: 21 / 32

ASUS AP5000 Installation Guide 21
III. Integration Procedures
III. Integration
Connections
CAUTION
* PLED cable, 3-wire (Orange/Black/
Green), connects Green to position #1
of PLED jumper.
* SLED cable, 3-wire (Green/Black/Red)
connects Red to position #1 of SLED
jumper.
* KEY cable, 2-wire (Black/Red) connects
Black to position #1 of KEY jumper.
* SCSI_ID cable, 8-wire, connects be-
tween SCSI_ID jumper of slot card and
ID jumper of SCSI drive. Be sure their
SCSI ID matched
* ALED_IN cable, 2-wire, connects be-
tween ALED_IN of slot card and access
jumper of SCSI drive.
Fig 3-20: Jumper Location & Cabling with SAF-TE Features
Installing a slot card
To install a slot card with a Hot-Swap drive bay, there are two types of
cabling methods as shown below; One is for SAF-TE back plane boards
(Fig: 3-20), another is for none SAF-TE back plane boards (Fig: 3-21).
SAF-TE back plane boards
To install SAF-TE one, the five cables should connect to the slot card and
the connections on the other end should be; two cables for SCSI device and
the other three for drive bay, shown below:
KEY SLED PLED ALED_IN SCSI_ID
1 1 1
Jumpers for Drive Bay
Jumpers for SCSI Drive