AstronSCIENTIFIC Rotarion Photo, Инструкция по эксплуатации

Страница: 27 / 45

11. With the tightening nuts of the stainless arms and the
assembly of the manual collimation nuts, there is only
left the connection of the 3 pairs of cables to the red
and black connector on the back of the ROTARION.
You will group together and thread together a white
wire of each stainless steel arm in the red connector
(A), as shown in the lower drawing. Then you will
perform the same operation, grouping by twisting
and inserting a remaining white wire from each
stainless steel arm into the black connector (B). To do
this you select the black tubes once again and you
introduce the pairs of 2 cables in the black tubes, but
only in the white cables corresponding to the holes
where the handle that was extracted at the beginning
of Section 6, Point 1.
(B)
(A)
(A)
(B)
(B)
(B)
(A)
(A)