Publication No. 980956 Rev. A 346B User Manual
Astronics Test Systems
Operation 2-7
Sweep Input and Sweep UP-DN
The sweep input is a BNC connector on the rear panel. Input a square wave signal
with a level of 0 to 5 Volts at a frequency ten times the desired linear sweep rate.
The UP/DN terminal when at low level (0 Volt) causes the frequency to sweep
down and when at +5 Volt to sweep up.
The SWEEP UP can be activated by pressing the
and then
key. (There must be an input signal at the Sweep input jack on the rear panel).
Press the key
and it will sweep down. The
and
keys are used to
change the sweep direction. Press
and it stops the sweep.