Astro Machine ASTROJET 1000P, Руководство оператора

Страница: 11 / 38

SECTION 2
INSTALLING THE PRINTER
7
3. Rotate Locking Lever up to lock Separators in place.
4. Adjust Side Guides to within 1/32-inch of
media. Set Rear Guide so that media is raised
approximately 1/2-inch and rests on curve of
Rear Guide.
NOTE: When running 10-inch or longer or
heavy media you may have to set Rear Guide
so that it just touches the back of the media.
5. Turn Printer ON.
Turn Media Thickness Knob to set initial
printhead height as follows:
NOTE: These are initial settings. It may be
necessary to adjust the MEDIA
THICKNESS control to optimize
the print quality.
6. Press the ON LINE key, then press ENTER to test feed media.
Installing Printer Driver
Printer Driver (
included
) must be installed on your computer before you install the AstroPrint Software.
Follow the steps below to install the Driver:
1. Close any applications running on your computer
Restart the computer before installing the Driver.
2. Install the CD in the CD Drive. Click START . Then
click RUN , then type the following:
D
:\Setup.exe
(where D is the CD drive) then click OK .
3.
“Add Printer Wizard ( n.nn )”
window opens.
Click Next> .
4. Type in your Name and Company. Click Next> .
5. Select printer port LPT1 . Click Next> .
“Add Printer Wizard”
appears. Select your Printer from the
table below, then click Next>
Printer Driver
AstroJet 1000p Address Printer 5
Media Thickness Dial Setting
0.004" to 1/32" 0 to 2
1/32" to 1/16" 2 to 3
1/16" to 1/8" 3 to 7
1/8" to 1/4" 7 to 10