Operation
900005-00, 10/2015
Innovative Hearth Products
Envy™ Direct-Vent Gas Fireplaces
54
Installing the logs
WARNING
• Turn OFF all gas and electricity to the appliance before installing the logs.
• Do NOT install the logs until the appliance has been competely installed, the gas line connected and
tested for leaks, and the initial burner operation has been confirmed.
• Use of an unapproved log set in the fireplace will void the warranty and will result in incomplete
combustion, sooting, and poor flame quality.
• Logs get very hot and remain hot for up to one hour after the gas supply is turned OFF. Handle the logs
only when cool.
• This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to
appliance and prove hazardous.
• If the logs are not installed according to these instructions, improper combustion could occur. This could
result in the excessive production of soot and/or the colorless, odorless, toxic gas carbon monoxide (CO).
NOTE:
Turn off all electricity to the appliance before installing logs.
NOTE:
The log set and fire are artistically arranged to provide an asymmetrical fire. The fire does not burn in the left
rear quarter of the log set.
Table 29 - Envy Log Sets
2
3
6
1
5
4
Log Number
Description
1
Bottom Right Log
2
Rear Log
3
Bottom Left Log
4
Front Log
5
Top Right Log
6
Top Left Log
Catalog number for the entire set:
35” H8707
40” H8708
45” H8824
Table 29
is representative of all fireplace models. Logs 5 and 6 may vary in appearance from those shown above.
NOTE:
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs.
Proper log placement is critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not
impinge the flames. Follow the log placement instructions precisely.
