Installation
900005-00, 10/2015
Innovative Hearth Products
Envy™ Direct-Vent Gas Fireplaces
35
Initialize the remote control system
After completing fireplace installation, initialize the remote control system before operating the fireplace.
1.
Insert the three (3) provided AAA batteries into the battery bay in the transmitter. Correctly align polarity (+/–).
2.
Insert the four (4) provided AA batteries into the wall switch battery bay (behind the wall switch plate). Correctly
align polarity (+/–).
3.
On the wall switch, place the three-position slider switch in the REMOTE position (
Figure 28
).
4.
On the wall switch front cover, insert the end of a paper clip (or other similar object) into the hole marked PRG.
NOTE:
The Receiver will beep three (3) times to indicate it is ready to synchronize with the transmitter.
5.
On the transmitter, press the ON button. The receiver will beep four (4) times to indicate acceptance of the
transmitter’s command (and set the receiver to the transmitter’s specific code). The system is now initialized.
The receiver accepts commands via radio frequency from the transmitter and does not require line-of-sight for
operation. The remote control system can operate the following fireplace functions:
• Primary burner ON/OFF
• Auxiliary burner ON/OFF
• Dimmable light function
• 6-speed blower operation
• Flame height and heat output adjustment (six levels)
The slider on the wall switch can be set to one of three positions:
• ON (manual override)
• OFF (manual override)
• REMOTE (remote control)
See the
Operation
section on
Page 48
for more details.
Figure 28 - Wall Switch
Figure 29 - Transmitter (Remote Control)
Remote
Off
On
PRG
Three-position slider switch
in REMOTE position
Hot Fireplace Will Cause
Severe Burns
Never Allow Children to
Touch Glass or other Fire-
place Parts
WARNING
LCD Display
ON/OFF button
THERMOSTAT button
UP/DOWN
ARROW
button
MODE
button
WARNING
Fire hazard. Can cause severe injury or death. The receiver causes ignition of the
appliance. The appliance can turn on suddenly. Keep away from the appliance burner when
operating the remote system or activating manual bypass of the remote system.
CAUTION
Property damage hazard. Excessive heat can cause property damage. The appliance can
stay lit for many hours. Turn off the appliance if it is not going to be attended for any length
of time. Always place the Transmitter where children can not reach it.
