Astria.us.com
126807-01D
29
VARIABLE REMOTE MODELS OPERATION
Continued
To activate this function, press THERMOSTAT
button until the word SMART appears to the
right of temperature bulb graphic on display.
Use UP/DOWN arrow button to set desired
room temperature. The control system will
cycle the fireplace on or off to maintain se
-
lected temperature.
SMART
MAX
Figure 46 - Smart Thermostat Setting
ON
Figure 47 - Child Safety Lock-Out
CHILD SAFETY LOCK-OUT
This function lets you deactivate the remote
control buttons. It is active when the lock icon
is lit on the display.
To activate, press MODE button and UP ar
-
row button at the same time. To deactivate,
press again.
REPLACING HAND-HELD REMOTE
CONTROL ONLY
If your remote ever needs to be replaced you
will not need to replace the receiver.
To program receiver with a new hand-held
remote, insert a small pin or paper clip into
hole on receiver face plate marked PRG.
The receiver will beep 3 times to indicate it
is ready to accept a new remote transmitter.
Press the ON/OFF button on your remote
and the receiver will beep 4 times to confirm
it receives commands from the new remote.
To
Program
Receiver
Figure 48 - Programing Remote Control
to Receiver
Figure 49 - Correct Pilot Flame Pattern
Figure 50 - Incorrect Pilot Flame Pattern
Pilot Burner
Thermocouple
Thermocouple
Pilot Burner
Check pilot flame pattern and burner flame
patterns often.
PILOT FLAME PATTERN
Figure 49
shows a correct pilot flame pattern.
Figure 50
shows an incorrect pilot flame pat
-
tern. The incorrect pilot flame is not touching
the thermocouple. This will cause the thermo-
couple to cool. When the thermocouple cools,
the appliance will shut down.
If pilot flame pattern is incorrect, as shown
in
Figure 50
• turn appliance off (see
To Turn Off Gas to
Appliance
,
Page 27
INSPECTING BURNERS
• see Troubleshooting
,
Page 32
NOTE
: The pilot flame on natural gas units
will have a slight curve, but flame should be
blue and have no yellow or orange color.
ON REMOTE OFF
PRG
f i r e - p a r t s . c o m
