Astria.us.com
126854-01F
5
Six
Piece Log
Set
Piezo
Igniter
Flame
Adjustment
Knob
Control
Knob
Base
Assembly
Left
Side
Right
Side
Front
LOCAL CODES
Install and use appliance with care. Follow all local codes. In the
absence of local codes, use the latest edition of
The National Fuel
Gas Code, ANSI Z223.1/NFPA 54
*.
*Available from:
American National Standards Institute, Inc.
25 West 43rd Street, 4th floor
New York, NY 10036
National Fire Protection Association, Inc.
1 Batterymarch Park
Quincy, MA 02169-7471
NOTE
: Where listed vented decorative logs are required, thermostat
operation is not permitted.
UNPACKING
1. Remove logs and heater base assembly from cartons.
NOTE
: Do not pick up heater base assembly by burners. This
could damage heater. Always handle base assembly by grate.
2. Remove all protective packaging applied to logs and appliance
for shipment.
3. Check appliance for any shipping damage. If appliance is dam-
aged, promptly inform dealer where you purchased the appliance.
CAUTION: Do not remove the data plates from the
grate assembly. The data plates contain important
warranty and safety information.
COMMONWEALTH OF MASSACHUSETTS
REQUIREMENTS
These appliances are approved for installation in the US state of
Massachusetts if the following additional requirements are met:
• Un-vented Room Heaters shall be installed in accordance with
527 CMR 30.
• Installation and repair must be done by a plumber or gas fitter
licensed in the Commonwealth of Massachusetts.
• The flexible gas line connector used shall not exceed 36 inches
(92 centimeters) in length.
• The individual manual shut-off must be a T-handle type valve.
• Unvented appliances may NOT be installed in bedrooms or
bathrooms.
• A working smoke detector must be installed in the area where
vent-free appliances are installed.
Seller of unvented propane or natural gas-fired supplemental
room heaters shall provide to each purchaser a copy of 527 CMR
30 upon sale of the unit.
PRODUCT IDENTIFICATION
Figure 1 - Product Identification
OPERATION
This heater is clean burning. It requires no outside venting. There
is no heat loss out a vent or up a chimney. Heat is generated by
both realistic flames and glowing coals. This heater is designed for
vent-free operation with flue damper closed. It has been tested and
approved to ANSI Z21.11.2 standard for unvented heaters. State and
local codes in some areas prohibit the use of vent-free heaters. This
heater may also be operated as a vented decorative (ANSI Z21.60)
product by opening the flue damper.
SAFETY DEVICE
This heater has a pilot with an Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off the heater if there is not
enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo igniter. This system requires no matches,
batteries or other sources to light heater.
PRODUCT FEATURES