Operation
900004-01, 03/2017
Innovative Hearth Products
Aries™ Direct-Vent Fireplaces
54
Installing the logs - 40” and 45” Traditional Models
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log
placement is critical to prevent sooting. Place the logs in the gaps between fl ame peaks, so they do not impinge the
fl ames. Follow the log placement instructions precisely.
NOTE:
Do not cover the burner ports.
Table 39 - Log Set
1.
If necessary, remove the glass door
(
Page 55
).
2.
Locate the log placement brackets
(
Figure 51
)
.
Figure 51 - Placing log 1
Figure 52 - Placing logs 2 and 3
Glowing Embers
(Do not place glowing embers over burner slots)
Right Rear Log Bracket
1
Volcanic Stone
Log Rack
3
2
3.
Position rear log (1) on the left rear log bracket
(
Figure 51
)
4.
Position the left front log (2) and the right front log (3) against the log rack
(
Figure 52
)
.
5.
Position the left cross log (4) over the rear log (1) and left front log (2) with the front resting on the log rack
(
Figure 53
)
.
Figure 53 - Placing log 4
Figure 54 - Placing log 5
4
2
1
3
5
6.
Position the right cross log (5) on the right rear log bracket and over right front log (3)
(
Figure 54
)
.
Log Number
Description
1
Rear Log
2
Left Front Log
3
Right Front Log
4
Left Cross Log
5
Right Cross Log
Catalog number for the entire set:
H7667 - 40” Models
H7840 - 45” Models
4
5
3
2
1
NOTE
: It is important to ensure proper log placement per the
manual when installing these units. Verify pilot fl ame is not
obstructed. See Verifying Appliance Operation on
Page 40
.
