Astria.us.com
900720-00E
29
OPERATION
Continued
Figure 45 - Pilot (Natural)
Thermocouple
Igniter Electrode
Pilot Burner
SWITCHING ON
To turn the system on, press the Burner ON/OFF
switch to the ON position
(see fi gure on
Page 28
)
.
Once the start up process is complete, the main
burner and pilot will be lit.
REGULATING THE FLAME LEVEL.
1. To decrease the fl ame level to low, press the
Hi-Low switch to the ON position.
2. To increase to high fl ame level, press the
Hi-Low switch to the OFF position.
NOTE
: If the appliance is set to the low fl ame level
and turned off, it will light on high fl ame level and
then cycle to low fl ame level on the next fl ame
sequence.
SWITCHING OFF
To switch off the fi re, press the Burner ON/OFF Switch
to the OFF position.
WARNING: Do not convert
heater to use different fuel type.
Only use heater with fuel type
specifi ed.
BLOWER
OPERATION
WARNING: This fi replace has
a three-prong, grounded electrical
plug. This plug helps protect you
against electrical shock. Only con-
nect plug to a properly grounded,
three-prong receptacle. Do not cut
or remove the grounding prong from
this plug.
Access the blower control knob by pushing in on
the bottom corners of the fi replace screen, grasp the
bottom of the screen and pull out and up to remove
the screen. The blower control knob is located on
the left side of the fi replace fl oor.
The blower is thermostatically controlled. This
means the fi replace and blower will not turn on
and off at the same time. The fi replace may run for
several minutes before the blower turns on. After
the fi replace is shut off, the blower will continue
to operate until the fi replace temperature cools.
The blower also includes a variable speed control.
Turn the knob clockwise to turn the blower to the
high position. Continuing to turn the knob will
reduce the speed of the blower until it reaches a
preset low speed.
