Page: 7
Version : 11-04-016
Switch on the mains voltage, a light fitted next to the
Handset socket on the right hand side of the unit,
should be illuminated.
Test the Safety Switch mechanism on the arms
works properly.
Operate the lowering function and then lift the right
hand arm to ensure the motor cuts out.
Leave the mains voltage supply switched on as it will
allow the batteries to charge.
Remove the ‘P’ Trap & straight coupling from the waste
assembly.
Fit the waste and cable tie in position as shown.
Assemble the Basin:
Cover the support arms to protect the Basin.
Rotate the support arms so they are horizontal and place the up turned basin on the arms.
Fit the tap bodies to the basin as shown. Ensure there is 35mm of threaded body showing above
the basin deck to allow fitting the handle. Ensure the nylon washer is fitted under the handle
screw to remove any clearance on the spline.
Fit the 1/”-15mm tap adaptors
Fit the spout in position and connect the flexible hoses as shown.
Fit the overflow, hose and waste connection into the basin, apply a thin film of silicon sealant to
the faces to assist with sealing
Using the adjusting screw, set the overall length of the basin plug to 77mm.(may need adjusting
later)
Fit the plug operating actuator.
Attach the mounting bracket using screws.
Stand the lower cover in place, then:-
Fit the horizontal plug lifting rod in position and set the clamp to lift the plug. See measurements.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
